Datamax-oneil I-Class Peel and Present Option Manuel d'utilisateur télécharger pdf

Peel and Present Option

92-2324-01 Rev.D

1 2 3 4 5 6 7 8 9 10

Peel and Present Option 92-2324-01 Rev.D

Page 2

Page 3

1 Contents of the Peel and Present Kit This kit contains the following items: Peel and Present Assembly Platen Roller Assembly

2 Replacing the Platen Roller  Note: Inspect your printer and determine if the Platen Roller Assembly installed in your printer includes the Int

3Installing the Peel and Present Assembly  Position the Peel and Present Assembly on the front of the printer and then tighten the mounting screw

Page 7

4 Setup and Configuration The printer will automatically sense the presence of the Present Sensor and allow it to be enabled for present printing.

5  Peel off at least 20 inches of labels from the label backing. Route the label backing as shown below.  Route the Label Backing back to and

6 Periodic Maintenance The Peel Mechanism Rollers will need to be disassembled and cleaned approximately every 100,000 inches to ensure trouble free

Page 10

7Lower Rollers:  Remove the Peel Mechanism from the printer. Press in on the Latch and allow the Front Cover to swing open.  Push in on the Ta

Pas de commentaire

Datamax-oneil I-Class Peel and Present Option Manuel d'utilisateur