Datamax-oneil E-Class Mark III Printhead Bracket and Screw Upgra Manuel d'utilisateur

Printhead Bracket and Screw Upgrade 92-2594-01 Rev.A

19.) Tighten the printhead screw until the printhead is fully seated (Fig 19)Figure 1921.) Align the tabs and push the printhead cover until it snap

22.) Align the tabs and push up on the printhead mech until it snaps back into place (Fig 22)Tabs should line up as shownFigure 2223.) Close the pri

Overview Print quality issues have been identified when printing on tag stock with a thicknesses over 7 mil, or when back feeding small labels sho

1.) Open the printhead/ribbon carrier assembly by sliding the green button downward (Fig 1)Figure 12.) Gently push tabs outward and drop printhead m

4.) Gently push tabs inward to drop the printhead cover (Fig 4)Do NOT change the media sensor positionFigure 45.) Remove the printhead screw (Fig 5)

6.) Disconnect the printhead cable from the printhead. (Fig 6)7.) Remove the printhead from the printer.8.) Disconnect printhead cover from the bra

10.) Pull printhead cover through opening in bracket. (Fig 10)11.) The bracket should now be fully disconnected. Remove the springs from the bracke

14.) Place the hinge of the bracket in the ribbon carrier assembly as shown (Fig 14a).15.) Re-install one post of the printhead cover in the bracket

18.) Install the new printhead screw in place (Fig 18)Make sure the screw is captured by the printhead ground cableScrew captured in ground cableFigu