Datamax-oneil I-Class Mark II SDIO_USB Host Option Installation Manuel d'utilisateur télécharger pdf

SDIO/USB Host Option Installation

92-2593-01 Rev.A

1 2 3 4 5 6

SDIO/USB Host Option Installation 92-2593-01 Rev.A

Page 2

1 Overview This document describes the installation and use of the SDIO/USB Host option for the I-Class Mark II printer. Follow the steps to begi

2 Installing the Option Install the SDIO/USB Host Card as described below: A) Turn off and disconnect the power cord from the printer. Remove th

3 C) Remove the 5mm Screw and Cover Plate from the rear of the printer. Cover Plate5mm Screw D) Install the two 6mm Standoffs into

Page 6

4 E) Install the SDIO/USB Host Card into the printer. First insert the “Port” end into the cut-out in the rear of the printer. Then pivot the SDI

Pas de commentaire

Datamax-oneil I-Class Mark II SDIO_USB Host Option Installation Manuel d'utilisateur