Datamax-oneil microFlash 4t User Guide Manuel d'utilisateur télécharger pdf (Page 5)

MICROFLASH 4T PRINTER USER'S GUIDE

Using Batteries: General Guidelines

 If your printer came with batteries already installed,

remove the red, battery isolator labels. If your

printer did not come with batteries installed, see

Installing and/or Replacing Batteries on this page

 If you are storing your printer for a long period of

time, reinstall the battery isolator labels.

 Both batteries must be installed for your printer to

operate properly.

Installing and/or Replacing Batteries

1. Open the printer's cover (Figure 1).

2. If applicable, remove the batteries by pressing the

retainer clip outward with your thumb (Figure 2).

3. While pressing the retainer clip, lift the outside end

of the battery past the retainer clip.

4. Insert or replace the new batteries. Verify the

battery contacts are facing down and are on the

outside edge of the printer (Figure 3).

Figure 1 Figure 2

Figure 3

1 2 3 4 5 6 7 8 9 10 ... 21 22

Pas de commentaire

Datamax-oneil microFlash 4t User Guide Manuel d'utilisateur Page 5