Datamax-oneil microFlash 4te User Guide Manuel d'utilisateur télécharger pdf (Page 11)

MICROFLASH 4TE PRINTER USER'S GUIDE

Printing a Self-Test

1. After installing the paper, open the printer's cover.

2. Press and hold the red, self-test button for

approximately five seconds until printing begins.

3. After printing begins, release the red, self-test

button.

Configuring the Printer

The printer has many configurable settings. To

configure or upgrade firmware, download the Windows

configuration program at www.datamax-oneil.com.

Using Printer Data Cables

1. Select the appropriate cable for use with the host

and/or device you are using.

2. Insert the plug into the printer's data port

(Figure 14).

3. Lead the cable through the notch on the outside of

the printer's cover.

4. With the cable exiting the front of the printer, close

and latch the printer's cover.

Caution: If the red, battery isolator labels are

installed, remove them.

Figure 14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Datamax-oneil microFlash 4te User Guide Manuel d'utilisateur Page 11