Datamax-oneil Performance series GPIO Manuel d'utilisateur télécharger pdf (Page 6)

GP I/O Serial Installation | 2

5 GP I/O Serial Installation Guide

3. Remove all four 7mm nuts securing the present sensor cable connection cover to

the media cover.

Figure: 2 - 2 PCB Cover

4. Disconnect the present sensor cable connector and route the connector (male) out

of the opening.

5. Loosen all three (3) 2.5mm hex head screws from the upper cover mount.

Note: For an easier re-installation, loosen but do not remove the screws.

Figure: 2 - 3 Upper Screws

1 2 3 4 5 6 7 8 9

Pas de commentaire

Datamax-oneil Performance series GPIO Manuel d'utilisateur Page 6