Datamax-oneil RL3_4 User Guide Manuel d'utilisateur télécharger pdf (Page 33)

To set the printer to work in Presenter Mode, follow the following steps:

- Set the “Presenter Sensor Equipped” parameter to enable the presenter sensor.

- Calibrate the Presenter Sensor to store the media settings (liner and media).

These setting changes can be performed using the NETira CT configuration utility, (see section 3.3 for

more information on NETira CT).

Launch the NETira CT configuration utility, and query (connect) to the printer.

Enable the Presenter Sensor:

1) Click on the ‘Miscellaneous’

printer component.

2) Set the ‘Present Sensor

Equipped’ to Enabled.

3) After updating the “New Value”

column, click the Send button

to send this change to the

printer.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

Pas de commentaire

Datamax-oneil RL3_4 User Guide Manuel d'utilisateur Page 33