APEX 2 User Guide 7A300019-2 Rev. A
6 1.4 Using the Belt Clip The belt loop system consists of two parts: A knob located on the back part of the printer just above the battery
7 2 Loading Supplies 2.1 Adding Paper or Labels The printer can print text, bar codes and graphics on thermal receipt paper. See “Supply Specific
8 While pressing the Paper Door Release button, close the paper door. Release the Paper Door Release button and press the printer door unti
9 3 Using the Printer 3.1 Initial Power-Up and Self-Test Once the battery is charged and the paper is loaded an initial power-up self-test can b
10 3.2 Connecting the Printer The APEX 2 printer supports Serial RS232 and Bluetooth ™ as default configuration. IrDA or 802.11g communication
11 3.2.3 Dip Switch Functions Table 2 shows the available dip switch settings. Table 2 – DIP Switch Setting Dip Switch Function Switch # Swit
12 3.3 Serial Communication The RS232C Interface signals for the APEX 2 Series printers are terminated on a 6 PIN RJ type data connector locate
13 3.4 Infrared Communications (IrDA) Dip Switch #1 must be in the <ON> position and Dip Switch #2 must be in the <OFF> position.
14 Table 4 - Magnetic Card LED Indicator LED indicator State Status Green ON OFF Ready/waiting for card to be swiped. Good swipe - Card dat
15 4 Printer Maintenance 4.1 Print Head Cleaning Instructions The print head and platen roller may need cleaning after printing a number of rolls
16 The fast-charge controller checks the battery’s voltage and temperature before the start of the fast recharge process. If the battery voltag
17 As long as the amber LED is ON, the battery is accepting a charge and the charging circuit is OK. At the end of a 180 minute charge cycle t
18 4.6 Troubleshooting Problem Action Does not feed paper or has a paper jam • Remove any jammed supply • Reload paper supply Does not print •
19 4.7 Printer Supplies Part Number Description 78728S1-3 APEX 2, Standard with Class 2 BT 78728S1R-3 APEX 2, Standard with Class 2 BT and M
20
21 5 Specifications 5.1 Printer Specifications Height: 2.7 inches (68mm) Width: 4.2inches (107mm) Length: 5.4 inches (138mm) Weight: w/bat
22 5.3 Regulatory Notes 5.3.1 FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital de
23 6 Customer Support Datamax-O'Neil Americas Orlando, FL USA Monday - Friday 8:00am - 6:00pm EST Tel: 407-523-5540 Fax: 407-523-5542 tech_su
i Contents General Precautions...1 Safety ...
ii 4.2.2 Important Notes on Replacing Batteries ... 16 4.3 Verifying Battery Charge State...
1 General Precautions • Before using this product be sure to read through this manual. After reading, please keep the manual in a safe place for
2 1 Getting Started 1.1 Unpacking the Printer The APEX 2 portable printer is a full-featured portable receipt printer designed for various job en
3 1.2 Installing and Charging the Battery Cartridge Note: One battery cartridge is included with the printer. Similar to a cordless phone batter
4 1.2.2 Charging the Battery Plug the battery charger adapter output cable into the battery charger connector as shown. Plug the battery
5 1.3 Reading the LED Status The illustration below points out the location of the LED indicators described in Table 1 FIGURE 4: LED INDICATOR
Commentaires sur ces manuels