Datamax O'Neil Compact 4 Manuel télécharger pdf (Page 10)

A26618-A

ENG

Warning!

Before beginning any work on

the printer ensure that the

power cable is not connected.

- Open the printer.

- Turn the release lever to PRINT.

- Remove the retaining screw.

- Press carefully on the front part

of the head so that the two screw

heads become free.

- Carefully loosen the connector at

the rear.

• Handle the print head with

care.

- Mount the new print head.

- Insert the connector at the rear.

- Replace the retaining screw.

- Turn the release lever to lift the

printhead.

- Close the printer.

- Feed in the media.

- Turn the release lever to PRINT.

Changing the print head

• Ensure that the printed pattern

is even across the entire width of

the print surface. Any secondary

adjustment should be made accord-

ing to instructions in the “Print

head adjustment” section.

10 - ENGLISH

- Exit test mode by shutting off the

power switch.

For information on the printer’s status:

Conduct a test print

- Load the media.

Use an approximately 110 mm wide print width.

- Hold in the start button.

- Turn on the power switch.

A test print will occur.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire