Datamax-oneil M-Class Mark II Operator’s Manual Manuel d'utilisateur télécharger pdf (Page 14)

Chapter 2 - Printer Setup 8

The Media Sensor needs to be positioned so that the printer can detect the presence of media and

the top-of-form (except for continuous stock, where the TOF is set through the front panel.

To adjust:

1. With media loaded, as described in Section 2.2, grasp the Slide Tab and move the Sensor

Eye Mark into position over media according to the table below.

2. If loading media, return to the media loading instructions.

Media Sensor Selection and Adjustment

Media Type Sensor Eye Mark Position Sensing Required

Die-cut Near the middle of the label Gap

Notched Centered over the notch Gap

Reflective Centered over the black mark Reflective

Continuous Near the middle of the media Continuous



‘Sensor Eye’ Mark



Slide Tab

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Pas de commentaire

Datamax-oneil M-Class Mark II Operator’s Manual Manuel d'utilisateur Page 14