Datamax-oneil APEX 3 User Guide Manuel d'utilisateur télécharger pdf (Page 10)

1.4 Using the Belt Clip

The belt loop system consists of two parts:

 A knob located on the back part of the printer just above the battery door

 A click-on connector

To use the clip, insert the knob located at the bottom of the printer into the slot of the

connector. Pull down until a click is heard; the printer is now secure

 To release the printer, press inward on the two connector latches and pull the knob clear

of the slot.

Note: Do not force or pull the printer from the connector without pressing inward on the

two latches.

FIGURE 5: KNOB CONNECTION AND QUICK CLIP

Release Latches

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Pas de commentaire

Datamax-oneil APEX 3 User Guide Manuel d'utilisateur Page 10