Datamax-oneil APEX 3 User Guide Manuel d'utilisateur télécharger pdf (Page 13)

3 Using the Printer

3.1 Initial Power-Up and Self-Test

Once the Battery is charged and the paper is loaded, an

initial power up self-test can be performed.

 Press the <ON/OFF> switch once. This turns printer

on. LED #1 illuminates in green or blue depending on

the mode of communication.

o The printer will stay ON until it is manually tuned

OFF.

o If the printer is set for Bluetooth™ (BT) mode the

printer will stay on all the time. Pressing the

<ON/OFF> switch again will turn the printer off.

 Press the <ON/OFF> switch to turn the printer off. The

LED turns off.

 To start the self-test, press and hold the <FEED>

switch then press the <ON/OFF> switches.

 The printer will start printing the self-test message.

Release the <FEED> switch.

o Press the <ON/OFF> or <FEED> switch to stop or

cancel the self-test print.

o The first few lines of self-test show the printer

firmware version, the current printer settings (for

example Bluetooth™ or Serial mode) and a list of

any optional or special features installed. Figure 9

shows a printing sample.

FIGURE 9: SELF-TEST

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Pas de commentaire

Datamax-oneil APEX 3 User Guide Manuel d'utilisateur Page 13