Datamax-oneil microFlash 2te Quick Reference Programming Guide Manuel d'utilisateur télécharger pdf (Page 44)

Using Easy Print Mode

Datamax-O’Neil Quick Reference Programming

T2:m - Enables or disables magnetic

card track 2.

m = ON :

enable track 2

m = OFF :

disable track 2

X X X

T3:m - Enables or disables magnetic

card track 3.

m = ON :

enable track 3

m = OFF :

disable track 3

X X X

}

A right bracket ends the command

set.

Commit {COMMIT}

{

A left bracket begins the command set.

COMMIT

Use the commit command to send two-letter configuration

commands to the printer. When the commit command is sent, the

configuration commands are written to Flash memory and the

printer restarts. When the printer restarts, it uses the default

configuration, (typically Line Printer mode). To perform additional

configurations, enter Easy Print mode and enter additional

commands.

}

A right bracket ends the command set.

Configure Magnetic CardReader {CMR:m} Values/

Format

Original 2t, 4t

CR SCR

Radio

Ready

2t,4t

SCR

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 71 72

Pas de commentaire

Datamax-oneil microFlash 2te Quick Reference Programming Guide Manuel d'utilisateur Page 44