Datamax-oneil microFlash 2te Quick Reference Programming Guide Manuel d'utilisateur télécharger pdf (Page 8)

Using Line Printer Mode

Datamax-O’Neil Quick Reference Programming

ESC @ Resets the printer 7

ESC Hn Multiplies the height n times 8

ESC R n International font selection 8

ESC ! n Sets double wide and double high 8

ESC EZ Goes to Easy Print Mode 9

ESC D n Increases the darkness 9

ESC d n Decreases the darkness 9

ESC bn Back up 9

Note: Line Printer commands are case-sensitive. Make sure you use the correct

case when entering commands. An n indicates binary numbers, not ASCII

characters. For more information, see the individual command(s).

Esc C n Set Form Length

Format ESC C n

Dec 27 67 n

Hex 1B 43 n

Function Sets the page length in character lines. In the command

format, n represents the number of lines in the form and n is

a single byte. The default for n is 20 decimal, 14

hexadecimal. The range for n is 1-255.

Esc A n Set Interline Spacing

Format ESC A n

Dec 27 65 n

Hex 1B 41 n

Function Sets the number of blank dotlines that are fed between

character lines. The printer adds n (eight-bit binary number)

blank lines after completing the current line(s) and before

printing the next line.

The default value for n is zero where n equals the number of

inter-character blank dotlines in a single character. The range

for n is 1-155.

CAN Cancel Line Buffer

Format CAN

Dec 24

Hex 18

Function Cancels the character received on the currently forming, but

not yet printed, line.

Command Description Page

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 71 72

Pas de commentaire

Datamax-oneil microFlash 2te Quick Reference Programming Guide Manuel d'utilisateur Page 8