Datamax-oneil Performance series Present Sensor Manuel d'utilisateur

Present Sensor Installation | 29 Present Sensor Installation Guide12.Fasten the present sensor assembly to the printer front cover.Figure: 2 - 8

2 | Present Sensor InstallationPresent Sensor Installation Guide 1014.Connect the ribbon cable from the present sensor to the connector on the PCB

Present Sensor Installation | 211 Present Sensor Installation Guide16.Ensure the cable is routed properly through the ferrite.Figure: 2 - 11 Cabl

2 | Present Sensor InstallationPresent Sensor Installation Guide 1217. Insert the connector through the slot in the cover.Note: The ferrite should

Present Sensor Installation | 213 Present Sensor Installation GuideNote: The remaining nut will be installed on a future step. Figure: 2 - 13 Cov

2 | Present Sensor InstallationPresent Sensor Installation Guide 1420.Insert the connectors through the opening in the box cover and secure the ca

Present Sensor Installation | 215 Present Sensor Installation Guide21.Route the left side of the cable cover into the opening in the PCB assembly

1 Present Sensor Installation Guide1 Safety Warnings and CautionsThe following Warnings and Cautions are used throughout this manual:Warning: Warnings

3 Present Sensor Installation Guide2 Present Sensor Installation Tools Needed• 2.5mm Hex Head Wrench• 3mm Hex Head Wrench• 7mm Nut Driver• #1 Phillips

2 | Present Sensor InstallationPresent Sensor Installation Guide 4Present Sensor Installation Procedure Note: Retain all hardware for reassembly.1

Present Sensor Installation | 25 Present Sensor Installation GuideCaution: Exercise caution when removing the cover set assembly and secure it in

2 | Present Sensor InstallationPresent Sensor Installation Guide 66. Press the cable chain bracket into the center plate opening.Figure: 2 - 5 Cab

Present Sensor Installation | 27 Present Sensor Installation GuideNote: The cable chain slot should face down.Figure: 2 - 6 Cable Chain 10.Reinst

2 | Present Sensor InstallationPresent Sensor Installation Guide 8Caution: Ensure the ribbon cable is securely connected to the present sensor sub