Datamax-oneil S2000i User Guide Manuel d'utilisateur télécharger pdf (Page 7)

2 Charging the Printer Battery

2.1 Charging the Battery Cartridge

Insert the battery Cartridge into the printer:

 Remove the battery door at the back of the printer, by placing a coin into the slot and pushing the cover to

release the lock (see Figure 2).

Install the battery cartridge in the battery compartment located at the back of the printer as shown in Figure 3.

Charge the battery cartridge before operating the printer:

 Plug the power adapter into an appropriate wall socket; then plug the power adapter cord into Power Input

Connector at the rear of the printer (see Figure 2). The yellow Charge light will illuminate, to indicate

battery is charging.

 The Charge LED turns off when battery cartridge is fully charged. It takes 60 to 90 minutes to fast charge the

battery pack.

 To insure full charge, printer should not be operated while the battery is charging.

Important notes on charging the battery:

The model 2000i uses 9 VDC/1A adapter to recharge the battery pack.

Each time the power adapter is connected to the printer, the battery Fast-charge is initiated.

Before the start of the fast recharge process, the fast-charge controller checks the battery’s voltage and

temperature.

If the battery voltage or the temperature is outside of the fast-charge limits, the charger defaults to trickle

charge at C/10 or 70mA rate.

Optional external battery charger is available for Datamax-O’Neil printers, a single bay fast rate charger and

conditioner and four bay 12 hours trickle charger.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Pas de commentaire

Datamax-oneil S2000i User Guide Manuel d'utilisateur Page 7