Datamax-oneil Class Series Programmer’s Manual Manuel d'utilisateur télécharger pdf (Page 110)

Extended System-Level Command Functions

Class Series Programmer’s Manual 96

STX Kp Module Protection

(Display-Equipped Models only)

This command controls memory module protection. When “protected”, a module will ignore format,

downloads and delete commands. This command can be useful to add data to Datamax-O’Neil

reserved modules, Z (ILPC) and Y (EFIGS). See Appendix K for a listing of the memory modules.

There are two types of modules: RAM (volatile) and Flash (non-volatile).

 RAM - When protected, if the power is cycled or if the printer is reset, the module state resets

back to unprotected.

 Flash - When protected, the module can be temporarily unprotected. However, if the power is

cycled or if the printer is reset, the module is initialized to ‘protected.’

Syntax:

<STX>Kpmf

Where:

Module ID – Range A to Z (See Appendix K).

Where:

Flag specifying Enable or Disable protection.

0 = disable protection

1 = enable protection

Sample:

<STX>KpY0

This example disables protection for memory module “Y”. Graphics may now be downloaded to

module “Y” and, on subsequent resets, these graphics will be protected.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 299 300

Pas de commentaire

Datamax-oneil Class Series Programmer’s Manual Manuel d'utilisateur Page 110