Datamax-oneil Class Series Programmer’s Manual Manuel d'utilisateur télécharger pdf (Page 86)

Extended System-Level Command Functions

Class Series Programmer’s Manual 72

(MCC) Module Command – This command adjusts the size of Flash module on the optional

Expansion Card according to the table below (see Appendix K for appropriate module details):

Value Module Command Units / Interpretation

Zxx xx

Size: 1 – 7 Mbytes. This is the amount to be allocated to Module

Z; any remaining

memory will be allocated to Module

Gxx xx

Size: 1 – 56, in 128 Kbytes blocks. This is the amount to be allocated to Module

any remaining memory will be allocated to Module

Table 5-4: Module Command

(ML) Maximum (Label) Length – See <STX>M for command details.

(MM) Menu Mode – This command sets the menu access level of the printer – where User is a

basic listing of menu settings and controls, and Advanced is a full menu listing.

(MT) Media Type – This command selects the printing method: Direct Thermal for use with heat

sensitive media or Thermal Transfer for use with media requiring a ribbon to create an image.

(For non-display models also see the <STX>KD command.)

(MV) Mark Value – This command sets threshold value for the reflective media sensor’s ‘mark’

parameter.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 299 300

Pas de commentaire

Datamax-oneil Class Series Programmer’s Manual Manuel d'utilisateur Page 86