Datamax-oneil DPL Programmer’s Manual Manuel d'utilisateur télécharger pdf (Page 98)

Extended System-Level Command Functions

(SS or sS) Feed Speed – This command controls the rate of label movement

between printing areas; see Appendix L.

(ST) Sensor Type – G for edge / gap, R for (reflective / black mark) or C for

continuous.

(SV) Switch Settings – This command controls recognition of the software switch

setting command <STX>V.

(TB) TOF Bias – This command controls the low-level voltage difference level to

recognize a label “gap” or “mark”.

(TD) TOF Delta – This command controls the low-level voltage difference level to

recognize a label “gap” or “mark”.

(TG) TOF Gain – This command controls the voltage to the LED emitter of the

Media Sensor.

(TN) No Paper Min – This command sets the media sensor level for the Out of

Stock (OOS) condition.

(TP) TOF Precedence – This command instructs the firmware to stop printing at

the first top of form mark it detects. The default (“No”) prints all of the data

(traversing the top of form as necessary) then slews to the next TOF.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 295 296

Pas de commentaire

Datamax-oneil DPL Programmer’s Manual Manuel d'utilisateur Page 98